1·The so-called big, generally refers to more than rock mineral content of 88% asphalt content.
含量大的含义，一般是指矿物含量超过岩沥青含量的88%。
2·The inspecting value of sample for asphalt content sampling of asphalt mix is normal distribution.
沥青混合料沥青含量抽样检测的样本检测值服从正态分布。
3·The asphalt content is one of the most important control targets in the production of the asphalt concrete.
沥青含量是沥青混凝土生产中最主要的控制指标之一。
4·Results and analyses show that the use of the additives will increase the optimum asphalt content by about 0.
试验结果与分析表明，各种添加剂的掺入将使最佳沥青用量增加约0。
5·These factors considered were asphalt content, confining pressure, temperature and frequency of dynamic force.
本文中所考虑的因素有沥青含量、应力状态、温度及动力的频率。
6·Stable conductive performance can be achieved by controlled graphite content and asphalt content and increasing the compact degree.
通过控制沥青用量和石墨用量，增加沥青混凝土的压实度，可获得稳定的导电性能。
7·Test results indicate that void ratio, asphalt content and density have great influence on road usage performance of recycle asphalt mixture.
试验结果表明，空隙率、沥青含量和密度对再生沥青混合料路用性能影响很大。
8·Then, it makes target mixture proportion design to study on the aggregate scope, optimum asphalt content of mixture, the temperature and time of curing.
进行了环氧沥青混合料目标配合比设计，确定了矿料的级配范围、混合料的最佳油石比以及高温固化温度、时间等参数。
9·From this analysis, it appears that the interaction of asphalt content and fine gradation has the most significant effect on the percentage of air voids.
从这分析，看起来，沥青内容和美好的渐进性的互作用有最重大的作用在空气空隙的百分比。
10·Based on the experiment results on three kinds of open graded ATPB, it is concluded that asphalt content should be above 2.5% and porosity should be above 18%.
本文经对三种开级配的沥青稳定碎石进行了试验研究，得出ATPB的沥青用量应在2.5%以上，空隙率在18%以上的结论。